Universal Super Shark Fin Antenna Car Radio Antenna Piano Paint Surface Suitable For Most Models Of Seat/Fiat/Chevrolet/Dodge

① Stick the double adhesive onto the bottom of the shark fin.
② Remove the original antenna.
③ Tighten screw and nut on the original antenna base.
④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.

Frequently Asked Questions

Question 1:Is super shark same color with original car color?
Answer 1:Super shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,please understand.

Question 2:Super shark installed on the roof have a little gap, is appropriate?
Answer 2:Super shark bottom is curve,most of hatchback models and SUV models no have gap,the sedan models roof is arc,there may be have a little gap,it does not affect the use.You can use adhesive in to the gap.

Question 3:How about the radio signal effect after installation?
Answer 3:This antenna using purification copper fittings,through our tested,the signal close to the original car antenna.

Question 4:What should be note when installing?
Answer 4:Clean around antenna base,be sure not have water and dust,first connect the cable and base,test the radio,if it is ok,than
installing,heating double adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpressing 3 minutes after pasted,keep dry in 2 days.